FPV Quad Parts

Peripherals and Replacement Parts

Equipment

Equipment Peripherals

Build Page Parts

Build Parts Equipment

Pre-Built Quads and Kits 

Build Page Parts Overflow

Build Parts Equipment Overflow

Compatibility Categories

Propeller Size

The props work with the motors to lift your quad off the ground.  Choose a prop size that fits your frame.  Higher pitch props are efficient in fast environments and are less responsive in slow speeds. Lower pitch props are efficient in slower environments and are more responsive in slow speeds. Beginners should try various pitch props to see what works best for them. 

Propellers

Motor Stator Size

The motors spin with the propellers to lift your quad off the ground. If you’ve picked a frame already, we show you which motors are appropriate for your frame. Beginners can choose motors with a similar stator size that others have used for the frame you’ve selected. Alternatively, calculate the thrust required for a particular thrust-to-weight ratio and learn to read motor thrust tables to select the best motors for your needs. 

Motors

Frame Size

The frame is typically the first part to pick because it determines what kind of flying you’ll be doing the most. Start by picking a frame type, and narrow down the options by propeller size. The frame holds your quad parts together and heavily impacts what the quad can do. 

Frames

Frame Kit

Frame Part Type

Frame Parts

Processor (MCU)

The FC is the brain or the CPU of your quad. It has a processor and other components that allow it to listen to your inputs and tells the quad what to do. FCs are commonly sold together with other components integrated or stacked (like ESCs and video transmitters). For beginners, choose a FC with a F4 or F7 processor that has a compatible mount with your frame. 

Flight Controllers

ESC Stack Mount

The ESC(s) controls your motors’ speed. It draws power from the battery to spin the motors based on what the FC tells it to do. Each motor needs an ESC. It’s common today to see 4-in-1 ESCs so you only need to buy a single part. For beginners, choose a 4-in-1 ESC that has a compatible mount with your frame and FC. The biggest consideration is amperage limit. We show you ESCs with appropriate amperage limits based on your frame size. You can calculate how much amperage you need based on your motor and prop choice. 

ESCs

Frame Stack Mount

FC Stack Mount

The VTX processes the image from your FPV camera and sends it to your goggle’s video receiver (VRX). If you chose as digital video system, you need a VTX that matches the system. Most analog VTXs and VRXs are compatible with each other, and your biggest consideration will be how much output power you need. The more output power, the more range and better signal you’ll get. Learn more about VTXs.

Video Transmitters

Built-in VTX

Built-in ESC

Flight Controller Part Type

Flight Controller Parts and Other Electronics

Single / 4-in-1 ESC

Firmware

Minimum Voltage

Maximum Voltage

VTX Antenna Connector

Antenna Connector

Antennas send signals to and from your VRX/VTX and RX/TX. Many video transmitters and radio receivers come with antennas. Ensure if you need them. Or choose upgrades to increase range and penetration. Select appropriate antennas based on connector, radio frequency, and polarization (if circularly polarized). 

Antennas

Antenna Frequency

Polarization

VTX Frequency

VTX Stack Mount

Max Transmission Power

Digital / Analog Camera

The FPV camera captures the image you see through the goggles. An FPV camera may be included with the VTX, particularly with digital VTXs. 

Quad Builder